EN 14989-1:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Manufacturer's declaration for type test
6 Dimensions and tolerances
7 Performance requirements
   7.1 Mechanical resistance and stability
        7.1.1 Vertical load on the air/flue terminal
        7.1.2 Wind load
   7.2 Hygiene, health and environment
        7.2.1 Gas tightness of the flue
        7.2.2 Gas tightness of the air supply duct
   7.3 Safety in use
        7.3.1 Thermal performance
        7.3.2 Thermal resistance
        7.3.3 Rainwater ingress
        7.3.4 Aerodynamic properties of the terminal
        7.3.5 Resistance to ice formation
        7.3.6 Resistance to penetration by foreign objects
        7.3.7 Materials
8 Product information
   8.1 Manufacturer's instructions
   8.2 Minimum information to be included in the
        manufacturer's instructions
   8.3 Sampling points
9 Marking
   9.1 Air/flue terminal
   9.2 Packaging
10 Designation
   10.1 General
   10.2 Temperature classes and test temperature
   10.3 Pressure class
   10.4 Condensate resistance class
   10.5 Corrosion resistance
        10.5.1 Corrosion resistance
        10.5.2 Flue duct material specification for terminals
   10.6 Resistance to fire (internal to external): Soot fire
        resistance and distance to combustible material
   10.7 Additional characteristics
        10.7.1 Wind class
        10.7.2 Ice/rain class
        10.7.3 Pilot flame class
11 Evaluation of conformity
   11.1 General
   11.2 Type testing
        11.2.1 General
        11.2.2 Further type test
        11.2.3 Sampling for type testing
   11.3 Factory production control (FPC)
        11.3.1 General
        11.3.2 Equipment
        11.3.3 Raw materials and components
        11.3.4 Product testing and evaluation
        11.3.5 Non conforming products
12 Test methods
   12.1 Mechanical resistance and stability
        12.1.1 Vertical load on the air/flue terminal
        12.1.2 Wind load
        12.1.3 Gas tightness of the flue
        12.1.4 Gas tightness of the air supply duct
   12.2 Safety in use
        12.2.1 Test environment
        12.2.2 Test assembly
        12.2.3 Hot gas generator
        12.2.4 Procedure
   12.3 Rainwater ingress
        12.3.1 Test assembly
        12.3.2 Procedure
   12.4 Aerodynamic behaviour of air/flue terminal
        12.4.1 Test assembly
        12.4.2 Test procedure
        12.4.3 Results
   12.5 Icing test
        12.5.1 Test assembly
   12.6 Resistance to penetration by foreign objects
        12.6.1 Test assembly
        12.6.2 Procedure
        12.6.3 Results
   12.7 Low temperature test
Annex A (informative) Typical dimensions
Annex B (informative) Sampling for factory production
                       control
Annex C (normative) Choice of size for type test and
                       sampling
Annex D (normative) Factory production control
Annex E (normative) Method of measuring the hot gas
                       temperature
Annex ZA (informative) Clauses of this European Standard
                       addressing the provisions of the EU
                       Construction Products Directive
Bibliography